6.2
Reconnect the radio to the computer
6.3
Open the CPS
6.4
Select Tools > Load Fixed Voice Data
6.5
Navigate to the ‘VoicePacket2015-03-23.fv’ and select it
6.6
Press the OK key to write the data to the radio
7.0
Front Panel Update Instructions
7.1
If you have not done so, check the front panel version using earlier procedures and confirm
whether an update is necessary
7.2
Keep the USB to DB-15 cable connected to verify completion of boot cycle prior to front
panel update start (see below)
7.3
Plug the USB Prolific to RJ45 front panel cable into the computer – confirm Windows
connection sound and settings in Device Manager
7.4
If not already done, set cable properties in device manager to 19200 baud rate and verify
COM port number
7.5
Connect the RJ45 to the front panel microphone port
7.6
Run ‘Upgrade Tool R1.02’
7.7
Set COM port number and baud rate as per information obtained from Device Manager
7.8
Press and hold P7 (volume knob, top left of panel) and power key to turn on radio
7.9
LED will show steady red and display will show ‘Program Mode’
7.10
Listen for Windows connection sound to confirm radio is ready for updating
7.11
Run ‘Upgrade Tool R1.02’
7.12
Leave Radio Type as DM6000, set Serial Port to COM port number for front panel cable,
set Baud Rate to 19200
7.13
Click ‘…’ button and navigate to Mobile_Panel_R1_00_04.fot’ and select it
7.14
Click ‘Flash’ button – LED will flash red and progress bar will cross screen in program
7.15
When update is complete, click OK
7.16
Hold power key for 5 seconds and release to shut down radio
8.0
Disconnect the radio from the computer