22
C.
Press
button to select quitting.
Note:
¾
Where the OST backup function is selected, the radio will save the OST code of
each channel even if the channel is changed or the machine is shut down.
¾
In the OST state, the LCD of the vehicle mounted radio and P2 icon will display.
¾
In the OST state, press “OST” button again and the QT/DQT of the radio will
return to the original position.
GPS Information View
If the radio starts the GPS function, you can view the current GPS information. The
specific operating steps go as follows:
A.
Press “GPS Information View” button to enter the GPS information display mode.
B.
Press
/
button until the items you require displays.
C.
Press
button for selection.
D.
Press
/
button for page up of the following content.
E.
Press
button to return to the previous operation.
The specific content can be shown as follows:
1.
Positioning star number: “STAR NUM”
2.
Longitude “LONGITUD”
3.
Latitude “LATITUDE”
4.
Altitude “ALTITUDE”
5.
Speed “SPEED”
6.
Time “TIME”
7.
Wired Clone Mode
Once the Wired Clone Mode is entered, the only way to exit that mode is too turn off and
on the power of the radio. The Wired Clone Mode can be enabled or disabled by the PC
Program Software.
The operating steps go as follows:
1
Press [P1] and [P2] on the host simultaneously while turning on the power. The host
display will show “CLONE” and enter the clone mode. If such a mode is not
allowed, it will enter the user mode.
2
Connect the two radios together with the cloning cable and then turn on the power
for the destination radio.
3
Press the [P4] button on the host to start the clone. At this time the red indicator will
light, the Display will say “CLONING” and the data will be transmitted to the
destination radio from the host. During the period when the destination is receiving
the data, it will show “PROGRAM” and the green indicator light will be illuminated.
After completion the host will show “SUCCESS” and the destination radio will
automatically restart.
4
Press the [P4] button and the host will return to the clone mode. To program another
radio start from Step 2.
