6
INSTRUCTIONS FOR THE RADIO TECHNICIAN
Connection of Power Cable
Check whether there is a hole for the power cable on the insulating board. If not, bore the
board with the suitable drill bit and fix a rubber grommet on it.
Have the cable pass through the insulating board into the car engine. Connect the red
conductor to the positive terminal of the Battery or an equivalent point and connect the
black conductor to the negative terminal of the battery or an equivalent point.
Make sure the wires are firmly attached and apply insulation as necessary.
Make sure the power cable is not too tight to allow convenient disassembly of the radio
while it is still connected to the power. This will allow you to attach the antenna to the
antenna jack without disconnecting the power cable.
Installing the Radio in the Vehicle
For passengers’ safety, fix the radio firmly on the fixed bracket so that the radio will not
be loosened in case of collision.
1
）
Mark a position on the instrument panel for the fixed bracket then drill a small hole
where it was marked. Install the fixed bracket with the 4 M5*16 self-tapping screws.
(Note: fix the radio at the position convenient for operation and control, and leave an
enough space for connection of the power cable and antenna cable.)
2
）
Slide the radio into the fixed bracket and attach it with 4 M4*10 combination screws
Use plus plain washers and spring washers as necessary. Different combinations of
holes are selectable to adjust the radio to the proper height and visual angle.
3
）
Connect the antenna and the power cable to the radio.
4
）
Install the microphone hanger at a position easy to use with the 2 M4*16 self-tapping
screws. (The microphone and its cable should be at a position not affecting safe
driving.)
5
）
Connect the microphone to the microphone jack on the front panel of the radio and
put it on the hanger.
Note:
When replacing the protective fuse for the power cable, please use the one of the
same specification.
