Mimic – NVIDIA® Jetson AGX Xavier™ to Jetson™ TX2/TX2i/TX1
Adapter
Users Guide
Document: CTIM-00502
Revision: 0.00
Page 13 of 16
Connect Tech Inc. 800-426-8979 | 519-836-1291
Date: 2019-03-12
Typical Installation
1.
Ensure all external system power supplies are off.
2.
Install the Jetson AGX Xavier™ Module onto the Molex Mirror Mezz™ Connector P2. Be sure to follow
the manufacturer’s directions for proper installation of mounting hardware, heatsink/heatspreader, and any
other applicable requirements from the manufacturer.
3.
Install the Mimic Adapter/Jetson AGX Xavier™ Module assembly onto the carrier. Mounting hardware
will vary depending on which type of module you are using, which carrier you are using, and the
application in which this system is placed.
4.
Install the necessary cables for application. At a minimum these would include:
a)
Power cable to the input power connector on the carrier
b)
HDMI video display cable
c)
Keyboard and mouse via USB
For additional information on the relevant cables, please see the Cables and Interconnects section of this
manual.
5.
Connect the Power Cable to the Power Supply.
6.
Switch ON the Power Supply. DO NOT power up your system by plugging in live power.
