Quark USFF Carrier User Manual
Users Guide
Document: CTIM-00080
Revision: 0.01
Page 17 of 20
Connect Tech Inc. 800-426-8979 | 519-836-1291
Date: 2020-02-27
Reset & Recovery Pushbutton
Description
The Quark USFF Carrier implements a dual functionality pushbutton for both Reset and Recovery of the
platform. To Reset the module, simply press and hold the pushbutton for a minimum of 250 milliseconds. To
put the Jetson module into Force Recovery mode, press and hold the pushbutton for a minimum of 10 seconds.
Function
Description
Location
SW1
Type
Panasonic EVQP7 Pushbutton
Carrier Connector
Part Number: EVQ-P7A01P
Manufacturer: Panasonic
Reset Button
Press
Minimum 250ms (typ.)
Recovery Button
Press
Minimum 10s (typ.)
Note:
A full power cycle of the AI Platform must be performed after module flashing.
LED Indicators
Description
The Quark USFF Carrier implements 2 LEDs for status indication as follows:
Function
Description
Location
D3 and D4
Type
Green LED
Carrier Connector
Part Number: APHHS1005CGCK
Manufacturer: Kingbright
Function
LED
Power LED
D2
System ON
D3
Typical Installation
1.
Ensure all external system power supplies are off and disconnected.
2.
Install the NVIDIA® Jetson
™
Nano / NVIDIA® Jetson
™
Xavier NX Module into the DDR4 260 Pin
SODIMM Connector (P1).
Be sure to follow the manufacturer’s directions for proper installation of mounting hardware, heatsink /
heat-spreader, and any other applicable requirements from the manufacturer.
3.
Install the necessary cables for your application. At a minimum these would include:
a)
Power cable to the input power connector
b)
Connect a Serial cable to UART2 pins on the I/O header
c)
Keyboard and Mouse via USB (a hub may be required for multiple devices)
d)
MIPI Camera(s)
e)
Using CBG117, connect the system to network
4.
Connect the Power Cable of the +5V Power Supply into the Power header (P5)
Plug the AC cable on the +5V Power Supply into the wall.
DO NOT
power up your system by plugging in live power.
