Quick
Start
Toolbar
Found under the menu bar, the toolbar provides shortcuts to major features. The toolbar
can be turned on or off by changing the Toolbar parameter found on the
View
menu. The
shortcuts available from the toolbar are as follows:
Create a new terminal configuration.
Open an existing terminal configuration.
Save the current terminal configuration.
Download the configuration to the terminal.
Download software to the terminal.
Configure terminals automatically over the wireless network.
View the PowerNet Twin Client Manager version.
The PowerNet Twin Client Manager is now successfully installed and ready for use. The
section below entitled
Quick Start
provides detailed instructions for quickly configuring
the terminal and starting a Telnet session.
Quick Start
This section describes how to prepare the Twin Client Manager and the Symbol terminal
for a Telnet session with the host. Following an initial serial download, the terminal
software and configuration are managed automatically over the wireless network.
Note:
Symbol terminals are normally delivered with Symbol files pre-installed. However,
if the terminal does not have those files installed, refer to the section entitled
Configuring the 9000 Terminal for Download
before proceeding.
Configuring the Manager
The first step is to configure the Twin Client Manager to meet site-specific requirements,
and then prepare it for the automatic management of the terminal software and IP
addresses. This simple procedure will require only a few minutes to complete.
Setting the Emulation
Click on
Start
,
Programs
,
PowerNet
, and
Twin Client Manager
.
Select the
Settings
menu, as shown below.
Supported Equipment Manual
•
June, 2006
2-5
