Release
Notes
Twin Client Setup
1.
If using an OpenAir server (IX or Windows), add this line to the configuration
file that you want to use Bluetooth printing on.
For COM4 add:
ptype=!57600,0,8,1,0,4,0,0;
For COM5 add:
ptype=!57600,0,8,1,0,5,0,0;
For COM9 add:
ptype=!57600,0,8,1,0,9,0,0;
2.
If using direct mode, add the lines below to end of the
"printers.txt"
file in Twin
Client Manager. This will allow you to select Bluetooth printing from the
normal pull down menus under printer selection.
Bluetooth - COM4,!57600,0,8,1,0,4,0,0;
Bluetooth - COM5,!57600,0,8,1,0,5,0,0;
Bluetooth - COM9,!57600,0,8,1,0,9,0,0;
IMPORTANT NOTE:
Normally with Bluetooth devices, you want to have them connected BEFORE you try to
use them.
What we have determined, in testing is; if it's connected BEFORE printing is started, you
will get various COM errors.
However, if you have the printer in a disconnected state, it seems to work fine. It makes
the connection on the print start, then closes the connection after the print ends.
You can check the connection status in the BT explorer. A right click will give you the
option to disconnect if connected.
Supported Equipment Manual
•
June, 2006
1-5
