Installation Manual
Connect
2
Car Anywhere GSM Kit
www.connect
2
car.com
25
12.
GENERAL SPECIFICATIONS OF CONNECT2CAR GSM KIT
Architecture integrates:
High-performance Dual Band GSM/GPRS core
12 parallel channel low-power GPS core
ARM7TDMI processor that controls all functions of the system
Power Control circuitry for Li-Ion backup batteries
Cooling/Heating system
Physical interfaces:
16-pin Molex connector (Type: Molex 43045-1609, and counterpart:
Casing: 43025-1600 and Box type spring contact: 43031-0001) for power
supply and I/O’s
SIM Card reader (Type: Molex-91228-0002 small SIM Card)
GSM antenna interface (Type: Connector 50. Fakra/Radiall SMB-male)
GPS antenna interface (Type: Connector 50. Fakra/Radiall SMB-male)
Power supply:
Supply voltage from +10.8 V to +32.0 V (absolute maximum ratings) suitable for direct connection to an
auto12V or +24V DC supply.
Current consumption: 250mA when internal battery is charging. 80 - 100mA when internal Battery is fully
charged.
Internal Battery stops charging when ever the vehicle Ignition is turned off (to minimize drain on the car
battery), and resumes charging automatically when the ignition turns back on.
The internal battery is only used when the vehicle battery drops below 8Volts, or is disconnected. This is
usually the case during a car theft where vehicle batteries are usually disconnected by vandals to disable
security systems.
Charging:
S
upports connection to a Li-Ion backup battery, also comes with an internal Li-Ion backup battery for up to 24
hrs of internal battery power when external power is disconnected.
Temperature:
Normal operation (without connected battery): -40 °C to +85 °C
Physical characteristics:
Size: 55.0 ± 0.15 mm x 80.0 ± 0.15 mm x 25.0 ± 0.15 mm
Weight: ca. 80 g
Size: 58.0 ± 0.15 mm x 119.0 ± 0.15 mm x 49.0 ± 0.15 mm
Weight: ca. 200 g
Audio:
1 Microphone input, one speaker output
Casing:
Fully shielded