Connectec Ct-AVL688, User Manual

Connectec

Ct-AVL688 User Manual

Connectec Electronics Co., Ltd.

                                                                                                                                    5/13

5F-3,No. 492,Bannan Road, Chung Ho Dist, New Taipei City 235, Taiwan 

TEL:+886-2-82216389     FAX:+886-2-82216626 

www.connectec.com.tw

service@connectec.com.tw

4 

Installation  

4.1    Check the Accessories first 

         Before using the GPS vehicle tracker Ct-AVL688, please check all accessories are   
                  complete. 

4.2    Install the SIM card 

4.2.1 Prepare a SIM card which has GPRS service and text messaging capability, and       

     remember to cancel the function of voice mailbox message and also cancel the   

     password locking.  

4.2.2 SIM card tray will pop up automatically when you use a sharp object pressing the   

     yellow switch next to SIM card connector.  

4.2.3 Place the SIM card with metal contacts toward up side then push the tray back into   

          the SIM card.   

4.3    Connect the Power Cable 

4.3.1 Use multi-meter to find permanent power 12VDC or 24VDC in the car. Then connect           

          the red line to the contact point, or directly connect the red line to the positive end of   

     car battery with well-protected cable handling.  

4.3.2 Use multi-meter to find the contact point which is greater than 5VDC when ACC is   

          ON, and 0VDC when ACC is OFF. Connect the yellow line to this contact point with   

     well-protected cable handling.   

4.3.3 Connect black line of the power cable to ground of the car, or directly connect to the 

negative terminal of car battery. 

4.4    Connect the Antenna 

4.4.1 Tighten the GPS / GSM antenna correctly into the SMA connector of GPS vehicle   

     tracker Ct-AVL688.  

4.4.2 Avoid GSM antenna being close to the metal surface or being next to the speaker or   

     car wireless radio transmitter.  

4.4.3 Install the GPS antenna toward the open sky, please choose the top of car or an   

          exposed position as possible for the best RF signal receiving. If it is necessary to   

     hide the antennas for the internal installation, please let the GPS antenna not   

     covered with any metal object.  

4.4.4 Avoid affecting the signal reception of antennas, extra parts of antenna cable should   

          be fixed and the whole cable handling should be without any bending or extrusion.