DX-1S Digital PABX - Programming Manual
3-3
2.
Press “/” again will disable the print out function and the message “Printer 1, Paused” will display in
the top right corner of the screen.
3.
If the printer is off line or problem happen, “Printer Error” will display in the top right corner.
Remark
1.
Default value = Printer 1, Paused.
2.
The printing message will output to Printer 1 Port only in Management Mode and a parallel printer
should connect to Printer 1 port to print out the message.
3.6
EXIT PROGRAMMING MODE AND SWITCH TO ATTENDANT CONSOLE MODE
The operation can exit Programming Mode and switch to Attendant Console Mode.
Operation
1.
Press “F4”.
2.
Message “Saving data . . . . . ” will display and the system is saving the programming data to Flash
Prom.
3.
If the message change to “Saving data . . . . . OK”, the programming data has saved to FLASH
PROM successfully.
4.
If the message change to “Saving data . . . . . ERROR” will display if the programming data cannot
save to FLASH PROM.
5.
The screen will change to Attendant Console Mode after 5 seconds.
Remark
1.
If the programming data cannot be saved to FLASH PROM, retry the programming process and save
the data again. If the programming data cannot be saved after retrying several time, there may have
problem in Module Control Card and should have the card replaced.
3.7
EXIT PROGRAMMING MODE AND SWITCH TO MANAGEMENT MODE
This operation is to use the programming command to exit the Programming Mode and switch to
Management Mode.
Operation
1.
Press “99” and then “Enter”.
2.
Message “Saving data . . . . . ” will display and the system is saving the programming data to Flash
Prom.
3.
If the message change to “Saving data . . . . . OK”, the programming data has saved to FLASH
PROM successfully.
4.
If the message change to “Saving data . . . . . ERROR” will display if the programming data cannot
save to FLASH PROM.
5.
Then the message “<<Management Mode>>” is displayed and the prompt is change to “M0>“.
6.
The console has left Programming Mode and returned to Management Mode.
Remark
1.
If the programming data cannot be saved to FLASH PROM, retry the programming process and save
the data again. If the programming data cannot be saved after retrying several time, there may have
problem in Module Control Card and should have the card replaced.
3.8
EXIT PROGRAMMING MODE WITHOUT SAVING PROGRAM DATA TO FLASH
To exit Programming Mode and switch to Attendant Console Mode but do not save the changed program
data to FLASH. The newly changed program data is stored in RAM but not in FLASH if exit with this
command. If the data in RAM is lost and the system will not be able to recover the data automatically
since the data has not been backed up in FLASH.
Operation
1.
Press “888” and then “Enter”.
2.
Then the message “Program data NOT save"
3.
The screen will change to Attendant Console Mode after 5 seconds.
Remark
1.
Since the programming data have not been saved to FLASH PROM in this case, if the data in RAM
is lost and the system will not be able to recover the data automatically.