DX-1S Digital PABX - Programming Manual
4-1
4
PROGRAMMING OPERATION
4.1
MFC-1S CONSOLE KEYBOARD FUNCTION IN PROGRAMMING MODE
The keyboard in MFC-1S Console is to input the programming command to the system. The function of
the keys in Programming Mode is as following:
Key
Function
0 ~ 9
Programming command
*
Separate different field of the command
.
Same function as “*”
/
Change Print out function
<
Backspace
<Enter>
Input command
F1
Change Console I.D.
Console I.D. will change from 1 to 4 then 1 again.
F2
Switch to BLF screen but do not exit Programming
Mode and do not save data.
F3
No function
F4
Save data and exit Programming Mode
Table 4-1 KEYBOARD FUNCTION IN PROGRAMMING MODE
4.2
PROGRAMMING MODE OPERATION COMMAND
There is a general format for programming and diagnostic commands. The first digit of all command is
Function Number and follows with optional parameters. All fields are separated by “*” or “.”. After
keying in the command, type “Enter” will execute the command. Some commands may not include all
the parameters.
Function Number
*
Parameter 1
*
Parameter 2
*
Parameter 3
*
Parameter 4 <Enter>
After the command is input, the system will proceed and give the result message on the screen. The
result message will indicate if the command is valid or there is an error.
Function
Number
Function
0
Display system software version and system clock
1
Set system clock
2
Display programming data
3
Set programming data
4
Display trunk programming data
43
Duplicate trunk programming data
5
Display extension programming data
53
Duplicate extension programming Data
6
Display speeding dialing memories
7
Store number to speed dialing memories / Clear speed dialing memories
8
System initialization
87
Contiguous extension directory number assignment
88
Return to Management mode immediately without save programming data.
The system will display “System busy…” when enter management mode
again before saving data complete.
