DX-1S Digital PABX - Programming Manual
5-46
5.7.24 PROGRAMMING ITEM 123 : TRUNK TO TRUNK GAIN
This is to program the transmission gain for Trunk to Trunk connection. If the value is larger, the signal
gain will be higher.
Command
3 * 123 * Value <Enter>
where Value = 1 ~ 255 : Gain (relative)
Note : For every unit offset from the default value, 0.1 dB is changed.
Default Value
Value = 208 (-3.5dB)
5.7.25 PROGRAMMING ITEM 124 : SYSTEM SOFT-RESET TIME
This is to program daily system automatic soft-reset time. With this feature enable, the system will
perform an automatic reset at the specified time. The following data will not be affected during soft-reset:
- Do Not Disturb
- Call Forwarding : Follow Me
- Busy and No Answer Transfer
- Wake Up Service
- Check In/Out Status
- Message Waiting
- User Defined Dialing Class
- Day / Night Mode Setting
- System Counters
Command
3 * 124 * Value <Enter>
where Value = 1HHMM : Enable auto soft-reset feature, HH = hour : 00~23, MM = minute : 00 ~ 59
Value = 0 : Disable auto soft-reset feature
Default Value
Value = 0
5.7.26 PROGRAMMING ITEM 125 : APPLY CALL RESTRICTION TO TRUNK GROUP
This is to program the status of Call Restriction to Trunk Group.
Command
3 * 125 * Trunk Group * Value <Enter>
where Trunk Group = 1 ~ 16
Value = 1 Enable Call Restriction
Value = 0 Disable Call Restriction
Default Value
Value = 1
5.7.27 PROGRAMMING ITEM 126 : E&M GAIN
This programming item is to set the E&M Gain. If the value is greater, the gain level will be higher.
Command
3 * 126 * Value <Enter>
where Value = 1 ~ 255 : Gain (relative)
Note : For every unit offset from the default value, 0.1 dB is changed.
Default Value
Value = 208 (-3.5dB)
