MS|2706|DS|04|19
FLEXI/FLEXI GOLD AND COMPAD
USER MANUAL
19
USING THE FLEXI UNIT
INTRODUCTION
Only ENROLLED USERS can have access to the secure area. Opening
the door is possible by placing the ENROLLED FINGER on the
fingerprint
Flexi sensor
located on the top edge of the
Flexi unit.
OPENING THE DOOR
–
(ENROLLED USER)
GETTING ACCESS
Upon sensing a finger placed in the sensor area, the
Flexi unit
‘wakes’ and enters the scanning and print matching stages. LED’s
surrounding the sensor provide visual notification of a failed or
successful fingerprint match
Step 1: Make sure the handle stays free in a horizontal position.
Step 2: Place the finger on the fingerprint
Flexi sensor.
Step 3: Keep the finger on until bleep and flashing
LED’s
.
(Note
1
)
Step 4: Push the handle down.
(Note
2
)
Step 5: Push the door and get access to the secure area.
Note
1
: If intensive flashing and no audible notification, USER fingerprint is
not recognized.
(Go to APPENDIX)
Note
2
: Handle will disengage in 5 seconds.
GETTING OUT
–
(SECURE AREA)
The Rear Handle (safe side) is permanently connected to the mortise
ensuring safe exit at all times, by anyone.
