MS|2706|DS|04|19
FLEXI/FLEXI GOLD AND COMPAD
USER MANUAL
22
•
If the LED’s are NOT flashing continuously, replace batteries
and try recognition again.
If problem persists reenrol the USER with the ComPad.
If problem persists, please contact
Technical Support
.
FREE HANDLE UPON RECOGNITION
If after recognition
(BLEEP)
, the spindle is NOT engaged by the handle:
-
Move the disengaged handle up and down and try recognition
again.
-
With an
ALLEN
key,
tighten the handle grub screw on the
outer side of the handle and try recognition again.
-
Is the handle at 90 degrees or has someone forced it?
If the spindle is NOT engaged by the handle any more, back up entry
must be used by the Euro Profile Cylinder
KEY
. Then,
change the
batteries
and try again.
If the problem persists, please contact
Technical Support.
ComPad DOES NOT SWITCH ON.
-
Make sure the “I/O” Button is
being pressed and held for
about 1 second.
-
Make sure the “I/O” Button is NOT
being pressed and held
during for longer as this will cause the
ComPad to start
switching off.
If the problem persists, change the batteries and try again.
If the problem persists, please contact
Technical Support