www.connects2.com
2
Connects2
Vision
CONTENTS
• Brake light camera with fixed 30cm cable to 4 pin, screw type connector.
• 10m Male to Female 4pin extension cable
• Instructions
INSTALLATION
1. Remove the third brake light from the vehicle and unplug the connection
cable
2. Connect the 4pin connector of the CAM-VW9.2 to the 4pin connector on
the extension cable, then attach it to the vehicle taking care not to trap any
cables
3. Connect the Black wire to a suitable ground and connect the Red wire to
the reversing light circuit or an interface which provides a reverse signal
4. Connect the camera to the display screen via the Yellow RCA connector
and ensure that the image is displayed correctly
Subscribe to our YouTube Channel for installation
guides and tips...
www.youtube.com/connects2
PAL / NTSC SWITCHING
PAL
Connect the Black terminal on
to the connector from the green
cable
NTSC
Disconnect the Black terminal on
the connector from the green cable