GARAGE DOOR OPERATOR USER’S MANUAL
3
1. Safety instructions
Carefully read and follow all safety precaution, warnings before attempting to install and use
this garage door operator, incorrect installation can lead to severe injury.
The installation should be carried out by a qualified technician.
To avoid electrical shock, disconnect the power cord from the mains power outlet before
doing any repairs or removing the cover.
The door operator must be grounded.
Before installation of the door operator, the door should be carefully checked for being
kept well balance. The door must be in good working order. Open and close the door
manually, make sure the door can be moved smoothly.
No one or vehicle is allowed to enter or leave the garage while the remoter is being
installed, do not allow children to play near the door.
Locate any fixed control: within sight of door but away from all moving parts of the door
and at a height of more than 1.5m above the ground to avoid children reaching it.
Keep remote controls away from children, to prevent the door operator from being
activated involuntarily.
When opening or closing the door, do not attempt to walk or drive through the door.
The door should only be operated when it can be observed to avoid accidents.
Install and adjust the manual release so that the handle hangs less than 1.5m above the
floor.
Our company reserves the right to change the design and specification without prior
notification.
Failure to comply with the instructions above may result in personal injury or property damage.
Our company does not accept responsibility for damage or injury resulting from installing this
operator.
2. Main features
The door operator is designed for garage door.
The control unit regulates all the necessary functions such as automatic lighting control,
automatic memory, automatic close, automatic reverse and photocell protection etc.,
extremely quiet and smooth operation.
Courtesy light will turns on in using and turns off after 3 minutes.
The operator memorizes the limit positions and unique braking system that slows the unit
down at the end of its travel. Soft start and soft stop control guarantees extremely smooth
and quiet operation.
Automatic reversion on obstruction during closing procedure.
The controller has a security LOCK function which prevents operation of the door from
transmitter.
In the event of power failure, the release device makes it possible to open and close the
door manually.
Hopping code remote control with max. 20 pcs hand transmitters.
Wiring terminals for battery, button switch, infrared photocell etc.
