5. . To start the program, type METEX and confirm with Enter.
Note!
To stop the program or should errors occur,
boot” the
computer
The use of Windows software is described below:
Attention!
. . . . . .
The following steps presuppose basic knowledge of
. . .
.
MS Windows. In case of difficulty, study the Win-
2.
3.
4.
5.
6.
dows manual concerning the use of WINDOWS.
Windows Version 3.1 or higher and a VGA monitor
(display) is required to run this software.
Start your computer and activate Windows.
Insert the floppy disk into the appropriate disk drive (A or
In Program Manager, open the file window and click “Run“ with
the mouse. As a result, a dialog box with a command line ap-
pears.
Type the following at the flashing cursor:
a:\scope\setup and press Enter, when the diskette is in drive a
b:\scope\setup and press Enter, when the diskette is in drive b
Follow the on-screen directions to complete the installation.
To start the program, with the left mouse button double-click the
SCOPEVIEW icon and then follow the on-screen instructions.
Pay attention also to the
file on the diskette for re-
marks concerning operation.
The
must be observed if you aenerate your own soft-
ware:
5 9
