44
"SNOOZE/CH" button
• Activate the snooze function during the alarm signal
• Quitting the manual setting mode and the alarm clock setting mode
• Switching between the channel displays (when using several outdoor sensors)
b) Carrying out manual setting
The setting mode is activated by pressing and holding the "SET" button for approximately 2-3 seconds
(afterwards the set value for the display contrast flashes at the top of the display)
By
briefly
pressing on the "SET" button you proceed to the corresponding following setting.
The setting mode is quitted automatically if no button is actuated for approximately 15 seconds (or if
all settings are effected one after the other). The last settings will be automatically saved.
Setting the display contrast
If not already done, activate the setting mode by pressing the "SET" button, as described in the
beginning of chapter 10.b). The set value for the display contrast flashes. Release the "SET" button.
Select the desired display contrast by pressing several times the "OUT/+" button.
You can set the time zone by briefly pressing the "SET" button. If no button is actuated for approximately 15 seconds,
the setting mode is quitted; the last setting of the display contrast is saved.
Selecting the time zone
If not already done, activate the setting mode by pressing the "SET" button, as described in the
beginning of chapter 10.b). The set value for the display contrast flashes. Release the "SET" button.
Briefly press once the "SET" button.
The set value for the time zone flashes (on the right next to the moon phase).
Select the time zone by pressing several times the "OUT/+" button (setting from 0 to 12 hours, or +12 to 0 hours).
You can set the time reception by briefly pressing the "SET" button. If no button is actuated for approximately 15
seconds, the setting mode is quitted; the last setting of the time zone is saved.
