40
41
9. Mounting
Before permanently mounting the brackets, please place all units in the desired
installation or mounting locations and check whether the outside area data are
correctly received. If this is not the case, then in most cases a slight shift of mounting
locations is sufficient for adequate signal reception.
A) Placement of the weather station
The weather station can be installed in free-standing fashion or mounted on a wall. Before
mounting on a wall, make sure that the outside temperature values can be correctly received at
the desired mounting location.
In addition, mount all units in locations where they are sufficiently protected against dampness
and rain.
Free-standing installation
The Weather Clock comes complete with a foldout stand that gives the option of table standing
or wall mounting.
Wall mounting
Choose a protected mounting location. Avoid direct rain or
sunlight.
Fix a screw into the desired wall, leaving the head extended
out the by about 5 mm.
Using the Weather Clock’s hanging hole, carefully hang it
onto the screw.
1.
.
B) Placement of the outside temperature transmitter
The bracket can be fixed at both ends of the
outside transmitter so that it can be mounted
on any flat surface.
The bracket can be mounted on a wall by
means of two screws provided.
For this, fasten the bracket with the help of
screws and dowels at the desired spot on a
vertical surface.
Fasten the outside transmitter into the
bracket.
1.
.
