leave the Auto Jumper plugged into the cigarette lighter socket for 1-1.5 hrs with engine or motor running.
This will provide enough charge for future use.
2.
Do not leave the Auto Jumper plugged into the vehicle cigarette lighter socket when the vehicle is not
running. This will not cause any damage to your vehicle battery, but may discharge the Auto Jumper.
Recharging the Auto Jumper by AC Adaptor at Your Home:
1.
Plug one end of the AC adaptor into the wall outlet at your home and the other end into the AC charging
input socket on the Auto Jumper.
2.
The charging time will take about 4-6 hours.
Using the Auto Jumper as a 12-volt DC Power Source:
1.
The Auto Jumper comes equipped with a 12-volt DC power socket.
2.
The socket of the Auto Jumper has a positive (+) center pin. Most, but not all, 12-volt DC accessories come
with this configuration.
3.
Before connecting any 12-volt DC accessory to the Auto Jumper, Check the polarity of the accessory (see
accessory owners manual).
4.
For DC accessories that do not have a positive (+) center pin, do not operate at 12 volts, or have a different
connector, you must use a DC to DC adapter (not included).
5.
The Auto Jumper is designed to operate a number of DC accessories successfully, such as 12-volt radios,
cellular phones and PDAs etc..
6. A DC to DC adapter set is required to run these accessory items and is available at most discount
department stores.
Technical Information:
- Battery Type: Sub-c Ni-Cad
- Voltage Output: 13.2V DC
- Fuse Size: 20A
