37
Page P.16
Important notes:
• The neutral position of the 3-axis gyro system „GU-344 GYRO“ may deviate a little. In this case, fine adjustment must be
performed using the trimming or subtrimming at the remote control transmitter.
• It is good if the control path for the throttle/pitch function does not exceed 80% so that the 3-axis gyro system does not
leave the control range when stabilising the flight position even at maximum pitch control. Therefore, the throttle/pitch
function should be reduced from 100% to 75% after setting the speed controllers.
• Observe the remaining capacity of the flight battery. If the battery is discharged too far, it will be damaged and the
quadrocopter cannot be controlled anymore.
• High gyro stability ensures stable hover flight. Low gyro stability decreases flight stability but increases the quadrocopter’s
agility.
Lower figure:
The 3-axis gyro system „GU-344 GYRO“ offers the possibility of switching from X to cross alignment.
Important!
Since the quadrocopter „500X-S“ is, however, only intended for X-alignment, alignment switching can be used only
for the quadrocopter „330X-S“, which is also shown in the figure.
