38
10. Programming the Speed Controllers
Page P.17
1. Call programming mode
Switch on the transmitter and move the throttle control lever to the full throttle position.
Connect the rechargeable battery to the speed controller. The motor connected to the controller emits 3 brief sounds with
increasing pitch and two brief separate sounds after two seconds.
After another 5 seconds, the connected motor emits 5 brief sounds with increasing pitch.
The controller is now in programming mode.
2. Call menu item
In programming mode, you will now hear 8 groups of different signals that are continually repeated in a loop. After the last
sound sequence (2 x long), the 5 brief sounds with increasing tone height will be audible again before the loop starts again.
Assignment of the respective signal sounds to the menu items can be taken from the following table.
No.
Sound sequence
Menu item or function
1
1 x brief
Braking
2
2 x brief
Battery type
3
3 x brief
Cut-off mode
4
4 x brief
Cut-off switching threshold
5
1 x long
Start mode
6
1 x long, 1 x brief
Timing
7
1 x long, 2 x brief
Call default settings
8
2 x long
Exit programming mode
To call a specific menu item, slide the throttle control lever to the bottom-most position (motor off) within 2 seconds of the
respective sound signal.
The speed controller thus switches to setting mode for the menu item called.
3. Adjusting values
In the setting mode, you will now also hear different signals (see top line of the following table), which repeat in a
continuous loop. The point where the sequence starts again depends on the menu item called, since only those sounds are
emitted for which a value is stored as well.
After the sound signal for the desired value, slide the throttle control lever from the bottom-most position (motor off) to the
full throttle position at once.
4 sounds (high, low, high, low) are emitted as confirmation for the stored value.
The speed controller returns to the programming mode, where you can call and set the next menu item if required.
1 x brief
2 x brief
3 x brief
Braking
Off
On
Battery type
Lithium
NiMH/NiCd
Cut-off mode
turn down
switch off
Cut-off switching threshold
low
medium
high
Start mode
normal
soft
very soft
Timing
low
medium
high
