38
• First use the button “ALARM” to select whether you want to change the settings for the High-Alarm (in the display “HI
AL”) or the settings for the Low-Alarm (“LO AL”).
- Briefly push the button “ALARM” 1x -> Change settings for High-Alarm (“HI AL”) (Alarm when exceeding a specific
measured value)
- Briefly push the button “ALARM” 2x -> Change settings for Low-Alarm (“LO AL”) (Alarm when undercutting a
specific measured value)
- Briefly push the button “ALARM” 3x -> Cancel; return to regular display
Each time, you will see if an alarm is active. For this, the icon “
HI AL
“ or “
LO AL
“ is displayed in the
corresponding display area.
If only the icon “
” is displayed, the respective other alarm is active.
• Briefly push the button “SET” repeatedly until the value you want to set flashes.
• Set the value with the button “+” of “MIN/MAX”. Keep the respective button pressed for quick adjustment.
• Briefly push the button “ALARM” while the value is flashing to switch the alarm on or off.
Depending on whether you are currently performing settings for High-Alarm (“HI AL”) or Low-Alarm (“LO
AL”), the icon “
HI AL
“ or “
LO AL
“ appears when activating the alarm.
When the wake-up time is active, the icon “
” appears above the time display.
• Use the button “SET” to switch to the next setting and proceed as described above.
• After setting the last value and pushing the button “SET”, you will leave the setting mode (alternatively do not push
any button for 30 seconds).
f) Terminating Wake-Up and Alarm Signal
Stopping the Alarm Signal
When the wake-up signal is triggered at the set wake-up time, the icon “
” appears above the time display.
The wake-up signal is automatically terminated after 120 seconds. To terminate it prematurely, push any key. The
wake-up signal is triggered again at the set time on the next day until you switch off the wake-up function.
Terminating alarm signal
When a set value (e.g. outdoor temperature) is exceeded or undercut, the weather station will issue an alarm (duration
approx. 120 seconds). The associated icon “
HI AL
“ or “
LO AL
“ will also flash in the display area for the
respective value.
To terminate the alarm signal prematurely, briefly push any button.
The corresponding icon “
HI AL
“ or “
LO AL
“ will continue to flash.
When the measured value leaves the warning range, the icons will disappear and the alarm is reset.
Observe that the signal sound will not be triggered again for the same alarm within the next 3 hours. This
is to avoid continuous alarm in case of fluctuating weather.
