23
Functional Description
Read all safety warnings and all
instructions.
Failure to follow the warnings and
instructions may result in electric
shock, fire and/or serious injury.
Intended Use
The machine is intended for hammer drilling in
concrete, brick and stone. It is also suitable for
drilling without impact in wood, metal, ceramic
and plastic. Machines with electronic control and
right/left rotation are also suitable for screwdriving.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 SDS-PLUS tool holder
2 Dust protection cap
3 Locking sleeve
4 Selector switch for drilling/hammer drilling
5 Battery charge-control indicator
6 Indicator for right rotation
7 Indicator for left rotation
8 Rotational direction switch
9 On/Off switch
10 Socket for charge plug
11 Charge connector
Technical Data
Rated voltage V=
14.4
Rated speed rpm
0–900
Impact rate
让
rpm
0–4800
Impact energy per stroke J
1
Max. drilling dia.
– Concrete (with twist drill) mm
10
– Steel mm
8
– Wood mm
16
Weight kg
1.2
Battery Li-Ion
Capacity Ah
1,5
Number of battery cells
4
Charging time
h
5-7
Please observe the article number on the type plate
of your machine. The trade names of the individual
machines may vary.
Noise emission values measured according to
relevant standard.
Acoustic pressure level
LpA 87 dB(A) K = 3 dB(A)
Acoustic power level
LwA 98 dB(A) K = 3 dB(A)
ATTENTION !
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
must be worn.
Weighted root mean square acceleration according
to relevant standard. :
10.85 m/s²
K = 1.5 m/s²
The declared vibration total value has
been measured in accordance with a standard
test method and may be used for comparing one
tool with another that the declared vibration total
value may also be used in a preliminary
assessment of exposure.
A warning that the vibration emission
during actual use of the power tool can differ
from the declared total value depending on the
ways in which the tool is used and of the need to
identify safety measures to protect the operator
that are based on an estimation of exposure in
the actual conditions of use (taking account of
all parts of the operating cycle such as the times
when the tool is switched off and when it is
running idle in addition to the trigger time).
Assembly
�
Before any work on the machine (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, set the rotational
direction switch to the centre position.
Unintentional actuation of the On/Off switch can
lead to injuries.
Battery Charging (see figure A)
Do not use other battery chargers. The supplied
battery charger is designed for the Lithium-
Ion battery in your machine.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, completely
charge the battery in the battery charger before
using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupting
the charging procedure does not damage the
battery.
WARNING
Do not continue to press the
On/Off switch after the machine
has been automatically switched off. The
battery can be damaged.
The battery is equipped with a NTC temperature
control which allows charging only within a
temperature range of between 0 °C and 45 °C. A
long battery service life is achieved in this manner
.
