25
The indicator for right rotation 6 lights
up when the On/Off switch 9 is
actuated and the motor is running.
Left Rotation: For loosening and unscrewing
screws and nuts, press the rotational direction
switch 8 through to the right stop.
The indicator for left rotation 7 lights up
when the On/Off switch 9 is actuated
and the motor is running.
Switching On and Off
To start the machine, press the On/Off switch 9
and keep it pressed.
To switch off the machine, release the On/Off
switch 9.
For low temperatures, the power tool reaches
the full hammer/impact capacity only after a certain
time.
Setting the Speed/Impact Rate
The speed/impact rate of the switched on power
tool can be variably adjusted, depending on how
far the On/Off switch 9 is pressed.
Light pressure on the On/Off switch 9 results in
low speed/impact rate. Further pressure on the
switch increases the speed/impact rate.
Battery Charge-control Indication
The battery charge-control indicator 5 indicates
the charge condition of the battery for a few
seconds when the On/Off switch 9 is pressed
through halfway of fully.
LED Capacity
All four LED’s are on >90%
Three LED’s are on >70%
Two LED’s are on <30%
One LED is on <=30%
Once only the one LED is lit ,the screwdriver must
be re-charged.
Temperature Dependent Overload Protection
When using as intended for, the power tool cannot
be subject to overload. When the load is too
high or the allowable battery temperature of
70 °C is exceeded, the electronic control switches
off the power tool until the temperature is in
the optimum temperature range again.
Additionally, the battery charge-control indicator
5 flashes green and red at the same time until the
On/Off switch 9 is released.
Working Advice
Apply the power tool to the screw/nut only
when it is switched off. Rotating tool inserts
can slip off.
CLEANING AND MAINTENANCE
Service
§ Only qualified specialist personnel and original
replacement parts should be used for repairs. This
will ensure that your device remains safe.
Cleaning
§ Regularly clean the machine housing with a soft
cloth, preferably after each use. Keep the
ventilation slots free from dust and dirt. If the dirt
does not come off use a soft cloth
moistened with soapy water. Never use solvents
such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
Lubrication
The machine requires no additional lubrication
GUARANTEE
Refer to the enclosed guarantee conditions
for the terms and conditions of guarantee.
ENVIRONMENT
Should your machine need
replacement after extended
use, do not put it in the
domestic waste but dispose of
it in an environmentally safe
way.
BATTERIES
Batteries
Unwanted batteries should be
disposed of in an environmentally
friendly way and in conformance
with the local regulations.
Discharge the battery by
letting the machine run at no load
speed until the motor stops.
Remove the battery from the
machine.
Hand in the battery as
chemical waste with the recycling
station in your municipality.
SERVICE DEPARTMENT
_ Damaged switches must be replaced by our after-
sales service department.
_ If replacing the power cord is necessary, it
should be done by the manufacturer or his agent
to avoid a hazard.
STORAGE
_ Thoroughly clean the whole machine and its
accessories.
_ Store it out of the reach of children, in a stable and
secure position, in a cool and dry place, avoid too
high and too low temperatures.
