6
✔
If your
appliance has a
hose to gas
connection, use
a wrench to
firmly attach
both.
✔
The hose used
for the gas connection shall
conform with the national
standards in force.
The maximum length shall be of
1,5m and it should not be metallic.
✔
To substitute the gas tank do as
follows:
- Close the empty tank valve.
- Connect the gas hose to the
pressure regulator of the new
tank, placing the seals against
leaks.
- Tighten the metallic clamp.
✔
Check for leakage at the
connections using water and soap.
If you observe bubbles, check the
connections and the seals.
Check again.
FIRST TIME USE
WARNING
Never allow the gas hose
to pass behind the heater
box.
WARNING
Do not turn the
Refrigerator on in case of
Gas leakage.
Call Technical Assistance
or the Gas Supplier.
To turn on your Refrigerator use the
following procedure:
✔
To be able to
carry out the
following
procedures,
remove the
protective hood
from the back of
the Refrigerator.
✔
Hook-up the gas supply.
✔
Set the thermostat button to the
coldest position.
ENGLISH
✔
The gas flask or outlet should be
located on the right side of your
Refrigerator.
✔
Push the selector valve button and
turn to the open position.
✔
Keeping the button pressed, ignite
the flame using the ignite button, do
this several times until the flame is
ignited. (Look through the sight-glass
to see the sparks and the blue flame
when ignited).
Gas Temperature
Control
Summary of Contents for CQG22
