19
When powered and in normal operational mode the amplifier will display
Volume In LED 1 as steady green.
When the amplifier is switched off using the On/Off button, audio is muted and
LEDs are not illuminated; press any button to turn the amplifier on again.
To adjust the staff volume level:
Press and hold the Volume In (+) or (-) buttons to increase or decrease the level.
The corresponding LED bar will show the volume setting.
To adjust the customer volume level:
Press and hold the Volume Out (+) or (-) buttons to increase or decrease the
level. The corresponding LED bar will show the volume setting.
For best possible performance:
1. Ensure the customer and staff volumes are turned completely down.
2. Adjust staff volume (Volume In) to a comfortable level.
3. Increase customer volume (Volume Out) until feedback is heard.
4. Decrease customer volume (Volume Out) until feedback is just eliminated.
Once you have followed the above steps:
1. The staff microphone is best positioned
no more than 300mm away from the
staff member.
2. Check the amplifier is fully functional by
ensuring the red ‘fault’ light is NOT
displaying.
If there is insufficient volume even after you have
adjusted the volume controls, enter engineers mode and raise max volume
settings. Exit engineers mode and repeat initial setup.
The system is now ready to use.
Using the System
Staff
microphone
