4. BIOS Setup
User’s Manual
37
I/O Device Configuration Window
Serial Port A :
[Enabled]
Base I/O address :
[3F8]
Interrupt :
[IRQ 4]
Serial port B :
[Enabled]
Base I/O address :
[2F8]
Interrupt :
[IRQ 3]
Serial port C :
[Enabled]
Base I/O address :
[3F8]
Interrupt :
[IRQ 5]
Serial port D :
[Enabled]
Base I/O address :
[2E8]
Interrupt :
[IRQ 11]
Parallel port :
[Enabled]
Mode :
[ECP]
Base I/O address :
[378]
Interrupt :
[IRQ7]
DMA channel :
[DMA3]
Floppy disk controller :
[Enabled]
F1
Help
↓
Select Item
-/+
Change Values
F9
Setup Defaults
Esc Exit
←→
Select Menu
Enter Select Sub-Menu
F10 Save and Exit
PhoenixBIOS Setup Utility
Item Specific Help
Advanced
I/O Device Configuration
↓
Configure port
using options:
[Disabled]
No configuration
[Enabled]
User configuration
Figure 4.5.
I/O Device Configuration Window (Factory Settings)
Serial port A
: This setting is for SERIAL1 on the equipment
connector plane.
Serial port B
: This setting is for SERIAL2 on the equipment
connector plane.
Serial port C
: This setting is for serial communication of the touch
panel port or for SERIAL3 on the equipment
connector plane.
Serial port D
: This setting is for RS-422/485 in the RAS connector
on the equipment connector plane or for SERIAL4
on the equipment connector plane.
Parallel port
: This setting is for PRINTER on the equipment
connector plane.
