4. Each Component Function
PT-310 User’s manual
21
Component Function
LED: POWER, ACCESS
There are 2 LED in front of this product.
Table 4.2. Display Contents of LED
LED name
State
Display contents
POWER LED
OFF
Indicates that this product is switched off.
ON (Green)
Indicates that this product is switched on.
ACCESS LED
ON (Orange)
Indicates that the SATA device is being accessed.
AC Power input terminal: AC-IN
To supply the power, always use the power supply listed below.
Rated input voltage: 100VAC
Range of input voltage: 100 – 240VAC
Power capacity: 100V 0.34A or more
Table 4.3. AC Power Connector
Connector type
W168A-3P-C (Made World)
Pin No.
Signal name
1
FG
2
100VAC
3
GND
Be careful not to connect power at wrong. In voltage, or the unit may cause a fault.
RESET SW: RESET-SW
RESET SW is provided.
When you set something different to support by using [System settings panel] or NFDisk is damaged
and so could not boot, the system can be reset to the default state by using the forced reset.
To perform a force reset, switch the power on while push the “Reset” button of the “Reset” button when
the lighting of “ACCESS” LED (in case of the PANECON-PC, the LED below the front side of the
panel) changes from orange into green.
If a force reset is performed, the system setting will be return to the default setting; the registry and
object store will not be restored.
CAUTION
CAUTION