Model RT-U50DSR
Universal Remote Control
Programming And Operating
Instructions
To have a clearer idea of the features and capabilities of
your remote control, take a moment to read these
instructions. Save for future reference.
© 2005, Contec Holdings, LLC, Rev. 08/05
1. Introduction
Your universal remote control is simple to program,
easy to use, and can operate up to five (5) devices,
which include:
SAT
Satellite receivers
TV
Televisions
VCR
VCR
DVD
DVD
AUDIO
Audio receivers, amplifiers, CD players
Before you can use your remote control, it must be
programmed (set-up) to operate the above devices.
2. Before Getting Started
Some of the special features and buttons on your
remote control are as follows:
Point and Press
®
Programming
Lets you program your TV, VCR, DVD, AUDIO
devices without codes. For more information, see
Sections 5 and 15.
Memory Guard
®
Eliminates reprogramming after battery changes.
Time Out
Shuts remote off if any button is pressed and held
for 30 seconds. This extends battery life in the
event the remote becomes lodged under or between
heavy objects.
3. Installing / Replacing Batteries
Install two (2) new “AAA” alkaline batteries as
indicated by the diagram in the battery compartment.
When the batteries become low and need to be
replaced, the [SAT], [TV], [VCR], [DVD], [AUDIO]
buttons will not illuminate normally or at all during use.
When this happens, replace the existing batteries with
two (2) new “AAA” alkaline batteries to restore normal
operation to the remote control.
4. Programming Your TV, VIDEO, AUDIO Devices
Code-Entry Programming
1. Turn on all the electronic devices (TV, VCR, DVD,
AUDIO) you want to program the remote to
operate.
2. Press [ENTER], then [MUTE] together until the
power / mode buttons illuminate in slow-rotation
(i.e. SAT
Æ
TV
Æ
VCR
Æ
DVD
Æ
AUDIO
Æ
SAT…).
3. a. To program your TV, locate the 3-digit code for
your brand in the TV Setup Code list and enter
it on the keypad of the remote control. Entry
of the correct code will cause your TV to turn
off. If multiple codes are listed for your brand,
you may have to enter several different codes
until
your
TV
turns
off.
b. As soon as you have entered a 3-digit code
that turns your TV off, press [MUTE].
1. If the TV turns back on, press [ENTER] to
lock in the code. The power / mode
buttons will blink 3-times and go out.
Or
2. If the TV does not turn back on, enter a
different 3-digit setup code until your TV
turns back on. Then press [ENTER] to
lock in the code. The power / mode
buttons will blink 3-times and go out.
4. To program your VCR or DVD, refer to the VCR /
DVD Setup Code lists and repeat steps 2 and 3
above.
5. To program your AUDIO devices, refer to the
AUDIO Setup Code list and repeat steps 2 and 3
above.
Point and Press
®
Programming
This method allows you to program the remote control
without using codes. Instead, the remote control
automatically finds the correct command that you
select in a variety of codes until you find the code that
operates your device. You then lock in the correct
code as described below.
