76” (193 cm)
68” (173 cm)
52” (132 cm)
54” (137 cm)
22” (55 cm)
4” (10 cm)
16” (41 cm)
29” (74 cm)
DRAIN AND
HOT/COLD WATER
48” (122 cm)
32” (81 cm)
IMPORTANT INSTALLATION
INFORMATION
Power Source:
120 VAC, 60Hz, 3Amp GFCI protected curcuit must be used to supply
power to the pedicure spa.
Plumbing:
Note:
You are responsible for your valves, connection, and compliance to
local codes.
•
Shut off valve is recommended.
•
0.5 inch fitting will be use for hot and cold water lines.
•
inlet backflow valve (optional - see specifications).
•
1.25 inch fitting will be use for the gravity drain.
•
3/4 inch fitting will be used for drain pump.
(Please see Wall drain/Gravity drain installation page for more
information)
Licensed Installation Required:
Please check your local plumbing and electrical codes. Installation of this
pedicure spa must comply with both. You must have a licensed plumber
and electrician complete applicable connections to your pedicure spa.
Note:
Failure to comply with federal, state, or local codes will result in
warranty being null and void.
INSTALLATION SPECIFICATION
To fully recline the pedicure chair, the base must be a
minimum
20 inches
from the wall.
OPTIONAL
DRAIN PUMP
7
NOT ALL
chairs are equipt with Air Vents.
The air vent connection can be
provided upon
request only.
Specification:
2” pipe.
*NOTE-
To achieve at least 50cfm
would depend on facilities set
up distance and size.
!! NOTICE !!
