BackFlow Valve
Vacuum Breaker for Inlet water may be needed.
This is based on
City Specifications. Please check with the city on their plumbing requirments.
Note:
Additional Pipe fittings may be needed for installation.
Operation Instructions
Sea Basin Operation
Adding Water :
1.
Prepare the basin following cleaning instructions on page 11.
2.
Place the Jet-Liner with AirJet in the bowl (See Instructions on next page).
3.
Add water to the basin by lifting the fill valve. Turn towards
RED
for hot water and
BLUE
for cold water. Continue to fill the water until the basin is full or else the water will
start to overflow.
CAUTION:
Always check water temperature before use. The water
temperature should
NOT
H[FHHGÜ)Ü&
4.
Turn off water by pushing handle downward.
5.
Press the silver On/Off button to start or stop Jet-Liner
Draining Water :
6.
Ensure the Jet-Liner is turned off by pressing the silver button.
7.
Pull on EasyDrain to rip the Jet-Liner and begin draining.
8.
If needed, Press the silver button to activate the drain pump.
9.
When the basin has been completely drained (Turn off the draim pump if needed),
remove and dispose the Jet-Liner (See instructions on next page).
9
