Contemporary Research 8
ICC2-ATSC 4S
On-Screen Menus (IC-RC Mode)
The remaining installation steps use the IR remote and the built-in character generator of the ICC2-ATSC 4S.
1.
Change the IR Remote mode in front-panel menu 18 to
IC-RC (18.0).
This will enable the character generator to
display the menus below.
2.
Touch
Menu
, then
999
, then
Enter
.
3.
The text
CR MENU>
should appear on the screen.
4.
Key in one of the commands shown below, then press
Enter
to activate.
5.
Note that, in Menu mode, the
Channel Down
key acts as a backspace/delete key.
CR Menu Number
Function
Unit Setup
45678
Display firmware version
45679
Display the unit’s device #. At this point, you can use the
Channel Down
key as a Delete key,
then enter a new d
evice # with the remote’s numeric keypad, then hit
Enter
to save the new
number.
45700
Display current make/model control type, listed on the previous page. You can use the
Channel Down
key as a Delete key, then
enter a new device # with the remote’s nume
ric
keypad, then hit
Enter
to save the new number. The setting will use the default baud rate,
which can be changed using front-panel menus.
45720
Set Display/Projector Input
Enter code 1-19. See page 15 in the
ER
section for input codes
45718
IR Remote Type
–
if you are done using the IC-RC mode, change this setting back to HD2-RC
operation.
0=IC-RC
1=HD2-RC
Special Menus
65478
Reset controller, similar to disconnecting power then restarting.
65487
Initialize to factory default settings: Power on, unlocked, display channel 11, channel ring set
to 4, 5, and 11, Group 0. Note that this command works even if TV power is off or control is
locked out.
65480
Enable constant Net transmit to the Head-End. This is used for measuring the signal strength
of t
he unit’s RF output. Press Enter to stop transmit or the unit will automatically stop after
50 seconds.
65481
Display DA transmitter frequency control voltage
–
should be 2000 - 3150.
65482
Display iCC-Net RF receive signal strength. Shows
Net RX
if receiving the
iC-
HE’s “heartbeat” pulse once per second,
!NET RX
if not.
65483
Display DF transmitter frequency deviation
–
should be 245 - 300
