English
CEIL6TC-MKII
- Compact projector with 6 RGB LEDs
Page 5
CEIL6TC-MKII projectors are passive, they must be connected to devices able to power them up and
control them.
Please find the wiring diagram below.
4-1 : Controller:
The controller allows to remotely control the power supply unit, and thus select colours. It uses the
DMX512 protocol and allows to command several channels, the PILOT-TOUCH, using 3 channels (Red,
Green, Blue) is used for the sake of this example.
4-2 : Power supply unit:
The power supply units transforms the command signal (DMX) into power signal (+48V 350mA max.) to
power up the projector LEDs. The PILOT-120, with 2 output zones, was used for the sake of this example.
4-3 : Splitter:
The splitter allows to multiply the number of projectors on the same chain. Most of the times, it also
allows to reduce cable length. It can feature RJ45 (LINK-SPLIT) connectors or waterproof connectors
(LINK-IPBOX).
4-4 : Cables:
RJ45 connectors are used for their simplicity and small size. They are different cable lengths (LINK-RJ).
Please make sure to connect your device as indicated below.
4 - Installation
Projecteurs
Splitter
Alimentation
Contrôleur
LINK-SPLIT
