Turning the Scanner ON/OFF
22
Wake and Sleep modes
With the main power switch ON, scanner power can be set in
Sleep mode
and
Wake mode
.
Sleep
mode is the energy saving mode. The scanner
cannot scan when in the
Sleep
mode.
Wake
mode is the full power ON
mode for scanner operation.
The scanner will go from
Wake
mode into
Sleep
mode:
Automatically: after a set idle time (see section:
Automatic shut down
after idle time
).
Automatically: with the Timer (see section:
Timer functions
).
Manually: when you hold the power button down for 3 seconds.
Hold down the power button to
enter Sleep mode
Scanner in Sleep mode
–
Power LED is orange
The scanner will go into
wake
mode:
Automatically: with the Timer (see
Automatic Power functions
).
When you feed a document into the scanner.
When you press any button on the panel.
Scanner in Wake mode
– Power LED is green
Advantages with using Wake-up and Sleep modes:
Ready faster:
You turn the scanner OFF and ON (sleep/wake-up) by
pressing the power key on the panel. The scanner skips its init sequence
and is ready to scan sooner than with
Main Power OFF
to
ON
.
Convenience
: When OFF (LED is yellow) the scanner can be powered up
(Wake-up) easily by pressing the power key or just by inserting paper into
the scanner, thereby indicating you wish to scan.
Timer function:
Scanner power with
Wake-up and Sleep
, can be setup
and controlled through the WIDEsystem software timer week schedule
feature or through an idle time setting.
Save energy:
Sleep mode runs at low power values.
