Contex HD Ultra X Series Replacement Instruction Download

Page: 2 / 6

HD Ultra X Series Instructions

Repeat for the other end of the
Guide Plate.

Lift the OTAC and remove the
brass spacers at both ends.

Carefully push the Gas Piston off
from the bracket, making sure
not to cause any damage.

Repeat for the other end of the
Guide Plate.

Summary of Contents for HD Ultra X Series

Page 2: ...Repeat for the other end of the Guide Plate 6 Lift the OTAC and remove the brass spacers at both ends 7 Carefully push the Gas Piston off from the bracket making sure not to cause any damage 8 Repeat for the other end of the Guide Plate ...

Page 3: ... the Top Lid Cover off from the chassis Replacing the OTAC Unit 1 When replacing the Guide Plate make sure the Gas Pistons go inside of the end plates 2 Position the Gas Piston over the pillars on the end plates at both ends 3 Lift the OTAC and refit the brass spacers at both ends ...

Page 5: ...lock in place to close 10 With the scanner powered up and the OTAC pushed down with the added 1 click on the ratchet make sure the LED for the raised lid is off 11 If the LED does NOT go out when the OTAC is closed then remove the rear panel to access the sensor to make adjustments Remove the T10 screws and lift the rear panel off from the back of the scanner ...

Page 6: ...n the locking screw and move the sensor bracket up or down until the Lid LED goes out 13 Retighten the screw 14 Retest the LED but raising the OTAC and pressing down adding the 1 ratchet click If the LED is correctly setup still off then refit the rear cover Video Work Instruction http www training contex com OTAC ...