4-10
Part replacement MG52D
Gas Spring for CIS Unit
*Switch Scanner off and disconnect from power source and PC prior to any repair.
Replace Gas Spring and reverse the steps.
1. Loosen screws.
2. Release pressure on Gas Spring.
3. Remove Screws.
4. Remove Gas Spring.
Remove LHS cover, see page 4-9
Click open CIS Unit so it stand in a vertical position.
Replace Interconnection Board and reverse
steps.
Interconnection Board
*Switch Scanner off and disconnect from power source and PC prior to any repair.
1. Disconnect ribbon cable.
2. Release lock and pull out flex cable.
3. Remove screws.
Remove RHS cover, see page 4-5