17
TO CHAGE A NEW BEER KEG
(5 liter universal keg)
When the beer in the keg runs out, before changing a new beer keg.
1.
Adjust the CO2 pressure regulation knob to “-” to shut off the CO2
supplying and save the CO2.
2. Open the top cover of the beer cooler, pull down the tap handle to
release the rest gas in the keg (maybe with some beer bubble).
3. Disconnect the gas tube and beer tube from the keg lifter by
pressing the white parts of the connector (see Figure 26). Take
out the keg by the keg lifter and pull out the piercing pin from the
keg (see Figure 27).
4. It is recommended to clean the tap mechanism when changing
the beer keg each time. Please refer to the below contents about
cleaning.
5. Then put the piercing pin into the new keg and put into the beer
cooler. Connect the gas tube and the beer tube to the keg lifter.
and CO2 connector, please press the
white button down
Figure 26
Figure 27
When you take out the beer connector
Lift it up
