7
INSTALLATION & OPERATION
A. INSTALLATION
1. Take out the beer cooler from its package. Place the beer cooler
on a steady and horizontal surface, and make sure the beer
cooler is at least 5 inches/10 cm away from other appliances or
wall on each side so as to allow correct ventilation on the
appliances, get better performance.
Figure 6
Figure 7
2. Install the tap handle connect to the tap, make sure both end fit
together perfectly. (Show as Figure 6)
3. Set the water drip tray into the notch provided. (Show as figure 7)
4. Plug in the beer cooler.
Note: Do not connect or disconnect the plug when your hands are
wet. Before use it, make sure the voltage is conformity with plug
mark, and check whether the power cord is well connected or not; if
not, please don’t use it, and call service center;
5. Put 800ml water into the cooling cavity or pour the water to the
max mark (Show as figure 8) (It can work without water, but it
can’t display the best performance)
Note: Make sure the drain switch is at “Off” position, and no extra
objects in the cooling cavity. (Figure 9)
Drip tray
