III. INSTALLATION
A. Unpacking
Your TV must be unpacked and handled by 2 persons to avoid any risk of deformation or shock on
the LED screen.
Start by preparing a flat surface covered with a soft, thick cloth (for example, a blanket). The
prepared surface should be larger than the size of the TV. It will allow you to lay the TV flat, LED
screen towards the floor.
Before removing the TV from its packaging, read the "Wall mounting" and "Installing the feet"
paragraphs to prepare for the selected operation.
Remove the TV from its packaging by lifting it vertically, then lay the TV screen flat on the
previously protected flat surface so that you can attach either the feet or a wall mounting bracket
(not supplied).
Packaging materials
- The packaging box is recyclable.
- Materials marked with the symbol are recyclable.
- >PE< = polyethylene; >PS< = polystyrene; >PP< = polypropylene; … This means
that they can be recycled by disposing of them in appropriate collection containers.
- Other packaging elements (adhesive, fasteners ...) must be disposed of with
household waste.
For more information: www.quefairedemesdechets.fr
B. Wall mounting
•
Contact a professional to get help with wall mounting your TV. We cannot be held
responsible in the event of damage or injury caused by the mounting of the TV.
•
The TV must be mounted on a vertical wall. This TV is not intended for mounting on a
sloping wall.
•
The TV must be switched off and disconnected from the mains when you mount it on the
wall. Failure to observe these precautions could result in the risk of electrification or
electrocution.
•
The mounting bracket must correspond to the distances shown below.
NOTE:
the supplied screws are used to attach the feet only. If you want to mount the TV on a
wall, contact a professional to find out how to install a wall mount.
Back view of your TV