Draft beer
Tilt the previously wet glass at 45 ° under the handle in the normal position
(1)
.
Operate the beer draft handle by pulling it toward you halfway (45 °,
position 2) to run the beer. The flow is at its maximum when the handle is
fully pulled (90 °, position 3).
At the end of filling, raise the glass upright and release the pull handle. It
automatically returns to position 1. The beer stops flowing.
E. Change of barrel
-
Unclip the pull mechanism.
❶
Press both buttons at the same time
.
❷
Remove the mechanism from the barrel collar and release the buttons
.
-
Put in place a new extension tube.
-
Install the new drum by following the steps detailed at the beginning of this
chapter.
