audible science
audible science
OPERATING INSTRUCTIONS
CONT.
MANUAL SPEED SELECTION CONT.
Simultaneously press “Speed Lower” and “Speed Raise”
push buttons on the Control Unit and hold down
for more than 5 seconds. A small “click” sound means
the Speed Control Computer is in adjustment mode.
Release the push buttons “ both LED lights should come
on the push buttons. If “ON steady” they indicate that
the speed is the same as the calibrated value.
To lower the speed of the Platter, push the “Speed Lower”
button . This will cause the platter speed to reduce by
0.1 r.p.m. each time it is pressed. The light on the push-
button will start to flash once the speed of the platter is
less than 0.1 r.p.m. than the previous calibration value.
Once you have set the desired speed, you must wait
45 seconds, with no further adjustments for the Caliburn
Control Unit to accept and store the setting into its
memory as the new user default. Should you wish to
make further speed changes, repeat this procedure.
OPERATING
YOUR
CALIBURN
page 20
