3
Dear customer, thank you for selecting the VIP Multimeter
for measurements of voltage, current, power and power
factor.
1.
Mechanical Installation
1.1
Please choose the proper place for installation in panel and prepare
a square hole according to exhibit below.
Space in the electrical panel
1.2
Please insert the VIP Multimeter into the suitable space which is
to be prepared in advance. Make sure that the device is inserted in
the right direction. The device has a plastic knob which adjusts
itself for installation in electrical panels. The thickness of the
panel door should be less than 4 mm.
Width
90 mm
Height
90 mm
NOTE!
Comment:
Please do not install the VIP Multimeter close to
electrical bars.
Please leave enough space for approaching the device from its
back side for providing technical support.
