Sensor Alignment
The Beacon series is equipped with visible target laser thru beam sensors. The transmitter
sensors (located in the secondary cabinet) shine much like a flash light. The target from
the transmitters can be visibly seen by simply placing a piece of white paper onto the
target area.
Each photo cell is mounted onto a bracket which is screwed onto a panel.
Loosening the screws holding the bracket to the panel will allow for some range of
motion up and down.
The sensors can also be tilted on the brackets themselves to provide a left-to-right
alignment adjustment. Simply loosen the screws holding the bracket to the sensor and tilt
in the desired direction.
Note that the light from the transmitters will actually be larger than the surface area of the
receivers. This makes alignment much easier. Try to center out the targets to the receiver
as close as possible.
Security Begins With Controlled Access
1636 W. 130th Street, Brunswick, OH 44212
Toll Free Phone: (800) 942-0829 | Fax: (800) 942-0828 / Phone: (330) 273-6185 | Fax: (330) 273-4468
12
