22
DIP SWITCH SET UP
SETTING THE DIP SWITCHES (SW1)
SW1 Dip Switch Settings
(located on the rear panel near the top left - see below).
Switch #1
- For restart options, set this dip switch to one of the following positions.
OPEN
= Manual restart required. Manual restart is provided for the user that requires systematic start-up of the
load. No power will be supplied to the load without manual intervention.
CLOSED
= Automatic restart active <Default> automatic restart allows the inverter to automatically restart following
a long term power outage. When the outage exceeds the back up time provided by the batteries, the Inverter will
shut down to preserve the long term life of the battery. When utility power is restored, the Inverter will deliver power
to the load and automatically recharge the batteries.
Switch #2
– Not used
Switch #3
– Not used
Switch #4
– Not used
ON (CLOSED)
OFF (OPEN)
1 2 3 4
ON
OFF
OFF
OFF
REAR VIEW OF INVERTER CABINET
SW1 DIP SWITCHES
SW1
“S” CABINET
“T” CABINET
SW1
Summary of Contents for MODEL ES
Page 51: ...51 APPENDIX A RELATIVE DRAWINGS SCHEMATICS APPENDIX A ...
Page 57: ...57 NOTES ...