HOSS - Owner's Manual 17
Using the system without the lock
If locking the wheelchair is not required, power down by pressing the On/Off switch. All indicators will go out.
To turn the system back on, press the On/Off switch. The system is now able to
be driven without the use of
the magnetic key.
Joystick OONAPU
All DX Remotes feature Out Of Neutral At Power Up (OONAPU) detection. If the system is powered up
or an inhibit condition is removed while the joystick is not in the neutral position, the System Status LED
flashes rapidly for either as long as the condition persists, or for a maximum of 5 seconds. Removing an inhibit
condition occurs in situations such as changing to a driving from a non-driving Drive Program, or removing a
battery charger. If the condition persists, after 5 seconds a DX Module Fault (Flash Code 1) is signalled on
the System Status LED, and the 7-segment display flashes. This is a latching fault and must be cleared by
powering the system down and up again (with the joystick in neutral).
To turn the power on press the On/Off button.
The current battery charge will be indicated and the
System Status LED will illuminate and not flash.
Press the On/Off button again to turn the power off.
Not available on your model.
Not available on your model.
Pressing the Horn button wiill sound the horn for as long as
the button is press.
Not available on your model.
Each press of the Mode button will increment the drive profile,
up to the maximum configured value and then back to profile 1.
The current drive profile will be shown in the 7 segment Display.
If accessory functions are present, further presses of the Mode
button will select these modes in turn. If accessories are inabled
but not present a '0' will be displayed.
10
On/Off Button
11
Headlights/Hazard Lights
12
Right Indicator
13
Horn
14
Left Indicator
15
Mode
No.
Item
Description
