8.1 AUTOMATIC THERMAL SAFETY
This device is equipped with an automatic thermal safety
feature. During abnormal operation (for example, blocked air
inlet or outlet), the device automatically stops.
Once the abnormal operation is corrected, and as soon as the
device has cool sufficiently, it will automatically restart.
NOTE
If the problem persists, contact your installer.
8.2 MAINTENANCE
To keep the device clean, CONVECTAIR recommends performing
regular maintenance. To remove dust, use a soft cloth. To
remove a stain, dampen the cloth.
For enhanced performance and maximum efficiency of the
device, it is recommended to remove dust regularly (once every
two weeks) by vacuuming the air inlets and outlets.
NEVER USE ABRASIVE OR ACETONE-BASED PRODUCTS, WHICH
COULD DAMAGE THE COATING OF THE DEVICE.
ALL WORK PERFORMED ON OUR DEVICES MUST BE DONE WITH
THE POWER OFF AND BY QUALIFIED AND CERTIFIED PERSONNEL.
FAILURE TO DO SO MAY INVALIDATE YOUR WARRANTY.
8.3 RECOMMENDATIONS AND ADVICE
Your CONVECTAIR device becomes hot when in use. Particular care
must be taken in order to educate young children.
Do not insert objects in the grids, as this may cause short circuits,
fires or damage to devices.
Any other use not recommended by CONVECTAIR may cause short
circuits, fires or injury to users.
Under special conditions, the heat diffusion grid may turn yellow
after some time. This phenomenon is not due to a manufacturing
defect. Rather, it is caused by the ambient air, which contains
smoke or suspended particles that are heated and then discharged
through the grid. This phenomenon is particularly noticeable on
“white” devices and can cause severe discoloration.
Prevention: It is recommended to clean the grids frequently,
especially for appliances installed in areas exposed to cigarette
smoke, in the kitchen, the bathroom or in rooms heated with a
wood-burning stove. CONVECTAIR devices must never be used
during construction work or other activities which generate large
amounts of dust.
When starting up the CONVECTAIR device for the first time, it may
emit light smoke caused by the heating of particles resulting from
the production. This phenomenon is completely normal and will
disappear automatically after 2 or 3 minutes of operation.
8. ADDITIONAL
INFORMA
TION
