ACAM_64
6
5
ACAM_64
Applications
•
Detection, tracking and recording of acoustic sources.
•
Soundproofing.
•
Mechanical product design for acoustical performance.
6
Getting Started
6.1
Software Installation
•
On the PC that is used to setup the instrument, run
Instrument_Manager_Installer.exe
. This
installs the
Instrument_Manager
application, as well as its USB driver and documentation.
Note: Perform the software installation above BEFORE connecting the instrument to the PC for the
first time. The installer includes the USB driver of the instrument, without which the PC will not recognize
the instrument.
6.2
Hardware Installation
1. Connect the instrument to an available USB port on the PC
2. Verify that the PC properly detects the instrument and wait for the PC to load the driver. In case
of doubt see section
6.3
Initial Test and Configuration
1. Upon connection to the PC, the LED should light-up red, yellow then green. The LED turning
green means that the instrument has finished its boot procedure, and that the PC has recognized
it.
2. Go into
Start\All
Programs\Convergence_Instruments\Instrument_Manager
and run
Instrument_Manager.exe
. The front-panel described in
tries to connect to the instrument. If it fails to find the instrument it indicates
No Device Found
. If
3. Otherwise, the application starts communicating with the instrument and the image should
change as the acoustic environment changes.