Remote Control
1.
POWER
Press this button to switch On or
set the device to standby mode.
2.
MUTE
Press this button to mute video
and audio on OUT A or B or on
all output. e.g. To mute output A
OUTA → MUTE
3.
OUT A/B
Press these buttons once a time
along with an IN buttons to select
an input source for an output
display. i.e. OUTA → IN1 → TAKE or
OUTB → IN10 → TAKE.
4.
IN 1~10
Press these IN buttons to select an
input from the 10 input sources.
5.
+/-
Press these buttons to move up/
down under menu selection.
6.
OK
Press to confirm the selection.
7.
CANCEL
Press this button to cancel the IN/OUT
selection and during any
selection under MENU.
8.
MENU
Press to enter into the menu selection.
9.
TAKE
Press this button to confirm the selection of an IN and an OUT
button. If this button is not pressed the IN & OUT selection will not
be executed.
10.
PRESET
Press this button to recall the preset setting from 1~10. Press and
select from IN1~10 then press TAKE to confirm the recall selection or
press CANCEL to exit the selection. To reset the Preset setting, enter
into menu and select Preset setting from IN1~10 then press OUTA
and select an input from IN1~10 then press OUTB and select an
input from IN1~10 again and press ENTER to confirm the selection.
eg. To preset 2’s figure, MENU → ENTER → Matrix Preset → ENTER
→ Preset2 → IN2 → OUTA → IN8 → OUTB → IN7 → ENTER
11.
LOCK
Press this button to lock all button functions on the panel to unlock,
press the button and hold for 3 seconds.
