Converters.TV CAR-1, Operation Manuals

MPM-CAR1

Features:

1. Digital decoding and encoding ensures best conversion quality.

2. Converts NTSC/PAL /SECAM composite video to RGB/Sync 

    or RGSB(Sync on Green).

3. Input system auto detecting.

4. RGBS input loop through.

5. Sync polarity switchable between positive and negative.

6. Output brightness adjustable. 

Operation Controls and Functions:

Operation Controls and Functions:

VIDEO INPUT

DC 12V

RGB OUT

RGSB

RGBS RESET

-

+

BRIGHTNESS

Front Panel

Rear Panel

1. DC power supply input: 

    DC 12V center positive.

2. Video Input.

1. + and - Buttons:

 Use these two buttons to increase or decrease the brightness.

Reset:

 Simultaneously depressing the + and - buttons return brightness to 

                 factory default.

2. RGBs/RGsB Switch: 

To select between RGsB(sync on Green)or RGBs.

3. 9-Pin D Females connector:

DB9    Pin configuration

PIN 1      GND

PIN 2      Sync of source 1

PIN 3      RED out

PIN 4      RED in from source 1

PIN 5      Green in from source 1

PIN 6      Green out

PIN 7      Blue out

PIN 8      Blue in from source 1

PIN 9      Sync out

Source 1: Loop-through RGB/S input.

Source 2: Video input.

Gray:

Brown:

Red:

Yellow:

Green:

Blue:

Purple:

Orange:

Black:

Specifications:

Input:

    Video input: 1 Vp-p 75 ohm RCA jack x 1

    RGBs input: Pass through

Output:

    RGB: 0.7 Vp-p 75 ohm 9-pin D Females connector.

    Sync: 3 Vp-p positive or Negative polarity

Power Supply:

 DC 12V center positive

Dimensions:

 94mm(D)x77mm(W)x30(H)mm

Accessory:

 One set of D-Sub 9-pin RGB bare wire 

                     and One set of 2-wire power cable.

Weight:

 0.4 Kgs

3

5

2

1

2

1

RGB out:

Bypass : short

Convert : open

Toggle Switch

Output   Select

Open           Convert
Short           Bypass

JP2

4. Toggle switch to switch between convert and RGB bypass.

Red

Black

12V

(Camera)

0V

4

When the control wire is connected to 12 Volt, it forces the unit to go into 

convert mode. When the control wire has no voltage apply to it, the toggle 

switch will dictate the convert/bypass mode.

C.wire

Output

T.Switch

Convert
Bypass

12V

0V

V in
V in RGB Bypass

V in

Blue

White

5. Control wires(12V Camera/GND)